Alvarion BreezeACCESS VL System Manual page 276

Appendix E - BreezeACCES VL MIB
MIB Parameter
*SoftwareRetrySupport
(*AdaptiveModulationParams 2)
*NumberOfSoftwareRetries
(*AdaptiveModulationParams 3)
*MinimumIntervalBetweenAdaptiveModulation
AlgorithmMessages
(*AdaptiveModulationParams 4)
*AdaptiveModulationDecisionThresholds
(*AdaptiveModulationParams 5)
*BurstMode
(*PerformanceParams 10)
*BurstModeOption
(*BurstMode 1)
*BurstInterval
(*BurstMode 2)
*ConcatenationParameters
(*PerformanceParams 11)
*ConcatenationOption
(*ConcatenationParameters 1)
250
Description
Applicable to all units.
only for units with version 2.0. Not
applicable for units with SW version
3.0 and higher. The status of the
Software Retry mechanism.
Enabled when the Adaptive
Modulation algorithm is enabled
and the Burst Mode Option is
disabled. Otherwise it is disabled.
Applicable to all units.
Read-only for units with version
2.0. Not applicable for units with
SW version 3.0 and higher. The
maximum number of times to use
the Software Retry mechanism
when it is enabled.
Applicable to all units. The
minimum interval between two
consecutive adaptive modulation
algorithm messages carrying
information on the SNR of received
signals.
Applicable to all units. Defines the
setting of thresholds for the rate
decision algorithm. high (2) should
typically be used when the SNR is
lower than 13 dB.
Burst Mode Parameters. Applicable
to all units. Not applicable if
Wireless Link Prioritization is
enabled.
Applicable to all units. Applicable
only if Burst Mode Option is
supported by the Sub-Band. Not
applicable if Wireless Link
Prioritization is enabled.
Enabling/disabling burst mode
operation.
In SU/RB with HW Revision B or
lower blocked (3) value is returned
when Security Mode is Wep, Data
Encryption Option is Enabled and
Burst option is Enabled.
In AU/BU with HW Revision B or
lower blocked (3) value is returned
when Dfs Option is Enabled and
Burst mode is enabled.
Applicable to all units. Not
applicable if Wireless Link
Prioritization is enabled. The burst
interval in milliseconds.
Concatenation Parameters.
Applicable to all units.
Applicable to all units.
Enabling/disabling the
concatenation mechanism.
BreezeACCESS VL System Manual
Value/Range
Read- Integer
disable (1)
enable (2)
na (255)
Integer
0-14
Integer
1-3600 (seconds)
Integer
normal (1)
high (2)
na (255)
Integer
disable (1)
enable (2)
blocked (3)
na (255)
Integer
1-the maximum value as
defined in the Sub-Band.
(milliseconds)
na (255)
Integer
disable (1)
enable (2)
na (255)