Kyocera 508ci Operation Manual page 311

Using Various Functions > Functions
Punch
Punches holes in sets of finished documents.
NOTE
• The optional 1,000-Sheet Finisher and punching unit or the optional 3,000-Sheet Finisher are required.
• For details on paper sizes that can be punched, refer to the following:
1,000-Sheet Finisher (page 11-27)
3,000-Sheet Finisher (page 11-28)
Punch Unit (For 1,000-Sheet Finisher) (page 11-28)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item
Punch
Original Orientation
*1 This function can only be used when the optional OCR Scan Activation Kit is installed.
Value
Off
2 holes Left
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Top Edge on Top, Top
*1
Edge on Left, Auto
Select the position of punch holes, and then select [Next >].
For details on original orientation and position of punch holes,
refer to the following:
Original Orientation and Punch Hole Position (page 6-29)
Select the orientation of the original document top edge to scan
correct direction. Select [Original Orientation] to choose
orientation of the originals, either [Top Edge on Top] or [Top
Edge on Left].
6-28
Description