Table of Contents
Advertisement
The following figure shows the basic sequence of the Autoload feature:
1. With the Autoload feature, you select a memory card file and the setting of the
mode selector.
2. Following a Power Off/ Power On of the PC, the PC loads the memory card file
that you selected beforehand.
3. Then, the PC writes this file to the load memory of the CPU 41x-2 PCI.
4. Then, the CPU 41x-2 PCI starts the loaded memory card file and goes to the
operating state specified in the memory card file (STOP, RUN).
Windows Automation Center, WinAC Slot Version 4.0
Hardware Installation and Operating Manual, Edition 02/2006, A5E00273194-02
STEP 7 Operations and Components
83
Advertisement
Table of Contents
