Decorative Barrier Front Dimensions For Finishing - Heat & Glo SL-5-IFT Installation Manual

D. Decorative Barrier Front Dimensions for
Finishing
Only decorative barrier fronts certified for use with this ap-
pliance model may be used. Contact your dealer for a list
of decorative barrier fronts that may be used.
Note: Refer to Section 3 for individual decorative barrier
front dimensions as installed on appliance.
Inside Fit - Firescreen Front (0-6 Inch Finishing)
DECORATIVE FRONT
NON-COMBUSTIBLE
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
Stop finishing material flush with fireplace surround opening.
Figure 10.9 Firescreen Decorative Barrier Front
= NON COMBUSTIBLE ZONE
Combustible materials NOT
allowed in this area.
Figure 10.10 Clean Face Kit Decorative Barrier Front
Heat & Glo • SL-5/5LP-IFT, SL-7/7LP-IFT, SL-9/9LP-IFT Installation Manual • 2632-980 Rev. E • 4/21
64
NON-COMBUSTIBLE
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
Adjustable Overlap Fit
FRONT FACE OF FIREPLACE
DECORATIVE FRONT
Non-Combustible Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
Figure 10.11 Overlap Fit Decorative Barrier Front
Overlap Fit - ARC,CHA,HAL, CHAF & IRON AGE
(1-6 Inch Finishing)
DECORATIVE FRONT
NON-COMBUSTIBLE
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
(Includes additional clearances to sides and top of decorative front)
Non-Combustible finishing material between
1 and 6 inches thick.
Refer to Section 3 for X and Y dimensions.
Figure 10.12 Overlap Fit Decorative Barrier Front
(ARC, CHA, CHAF, HAL, IRON AGE)
1 IN. MAX.
NON-COMBUSTIBLE
FINISHING MATERIAL
(TOP EDGE)
NON-COMBUSTIBLE
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
Y
X