Heat & Glo SL-5-IFT Installation Manual page 68

Install Rear Logs
1. Remove large rear left log from the packaging and install
the log by locating it on the back left log pin(s). The left
side of the log will reside within the indentation in the
left hearth component.
SL-7/SL-7-IFT and SL-9/SL-9-IFT Models: There
will be about a 1 inch rear gap between the left rear log
and the back wall of the firebox. There will be about a
1-1/2 inch side gap between the left end of the log and
the left side of the firebox. See Figure 4.
SL-5/SL-5-IFT Models: There will be about a 1 inch
rear gap from the left rear log to the back wall of the
firebox. There will be about a 1 inch side gap be-
tween the rear left log and the side of the firebox. See
Figure 4.
Note: Reference dimensions between logs and firebox
wall will need to be adjusted by 3/4 inch if the optional
refractory kit is installed.
SIDE GAP SIDE GAP
INDENTATIONS INDENTATIONS
Figure 4. Install Left Rear Log
2. Remove the large rear right log from packaging and
install it by locating it on the back right log pin(s). On
some models, it may be necessary to lift the left rear
log slightly to install the right rear log. The right side
of the log will reside within the indentation in the right
hearth component.
SL-7/SL-7-IFT and SL-9/SL-9-IFT Models: There
will be about a 3/4 inch rear gap between the rear
right log and the back wall of the firebox. There will be
about a 1-1/2 inch side gap between the right end of
the log and the right side of the firebox. See Figure 5.
SL-5/SL-5-IFT Models: There will be about a 1 inch
rear gap between the rear right log and the back wall
of the firebox. There will be about a 3/4 inch side gap
between the right end of the log and the right side of
the firebox. See Figure 5.
Heat & Glo • SL-5/5LP-IFT, SL-7/7LP-IFT, SL-9/9LP-IFT Installation Manual • 2632-980 Rev. E • 4/21
68
REAR GAP REAR GAP
Figure 5. Install Right Rear Log
®
Install Glowing Embers
3. Remove Glowing Embers
the ember material as shown in Figure 1. Care should
be taken to avoid placing ember material directly over
ports and to avoid using excessive amounts of ember
material.
WARNING! Risk of Explosion! Follow ember place-
ment instructions. DO NOT place embers directly over
burner ports. Replace ember material annually. Improp-
erly placed embers interfere with proper burner opera-
tion.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• When placing Glowing Embers
should be taken so that the ports are not covered. Place
the dime-size ember pieces near the port holes in the
burner top. Failure to follow this procedure will likely
cause lighting and sooting problems.
INDENTATIONS INDENTATIONS
Figure 6. Glowing Embers ® Installed
SIDE GAP SIDE GAP
REAR GAP REAR GAP
from packaging and install
®
onto the burner care
®