Decorative Front Dimensions For Finishing - Heat & Glo SL-550TR-E Installation Manual

C. Decorative Front Dimensions for Finishing
Only decorative fronts certifi ed for use with this appliance
model may be used. Contact your dealer for a list of dec-
orative fronts that may be used. Once you have deter-
mined what kind of decorative front and fi nishing material
is going to be used on the fi replace, use the information
below which shows the decorative front models and the
non-combustible fi nishing material thickness allowed.
DECORATIVE FRONT
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
Stop fi nishing material fl ush with fi replace surround opening.
Figure 10.8 Inside Fit Decorative Front (Folio)
= NON COMBUSTIBLE ZONE
Finishing material up to 4 inches thick may come to the
appliance surround opening on the sides and cover the top
and bottom vanity panels.
Figure 10.9 Inside Fit Decorative Front (Clean Face)
Heat & Glo • SL-550/750TR-E, SL-550/750/950TR-IPI-E Installation Manual • 2118-910 Rev. C • 4/16
FINISHING MATERIAL
4 IN. MAXIMUM THICKNESS
FRONT FACE OF FIREPLACE
DECORATIVE FRONT
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
Figure 10.10 Overlap Fit Decorative Front (Chateau and Halston)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
(Includes approximately 1/8 in. opening each side of door)
Finishing material between 1 and 4 inches thick.
Refer to Figure 3.3 for X and Y dimensions.
Figure 10.11 Inside Fit Decorative Front (Chateau and Halston)
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
FINISHING MATERIAL
4 IN. MAXIMUM
THICKNESS
DECORATIVE FRONT
X
Y
53