Di Driver Setup Window - National Instruments NI DIDS-2103 User Manual

The purpose of the DI Driver Setup window is to configure the Direct Injector (DI) Driver Module to the desired
settings. A DI Driver System can have up to four DI Driver modules, DI1 through DI4. There is a
corresponding to each DI Driver module. Each DI Driver module can be configured with independent boost voltage,
current profile and operating modes. For more information on DI Driver Module slot assignment, see the
setup section.
DIX_ModulePresent
Tip Strip: Indicates DI Driver module present and externally powered
Detail: Indicates the presence and recognition of the associated DI Driver module. The module will only be
recognized when
module is properly
DIX_ModuleEnable
Tip Strip: Enables DI Driver module operation
Detail: If a DI driver module is inserted in the
ON, then the controller begins communicating with the module and allows the module to operate.
DIX_Mode
Tip Strip: Selects operating mode for DI Driver module

4.1 DI Driver Setup Window

DIX_ModuleEnable is ON, a DI Driver module is inserted in the
externally powered.
assigned slot, externally
NI DIDS-2100 Series User Manual | © National Instruments | 61
DIX_Config
assigned slot, and the
powered, and DIX_ModuleEnable
window
hardware
is