Pfi Tab - National Instruments NI DIDS-2103 User Manual

The PFI tab is for configuring both EPT and TMP operating modes for the PFI channels of the PFI Driver module.
The EPT and TMP injection pulse command sequences support one pulse and apply it to all four PFI channels
of the module. The individual channel enable buttons, operating mode, and current profile parameters for the PFI
Driver module are configured via the
Module Control tab of the
Mode is selected in the
not applicable. The lowside driver channels of the PFI Driver module do not have the ability to be operated engine-
synchronously and are not configured from this tab (refer to
module is an optional module for DI Driver Systems and this tab is not applicable when the module is not present.
EPT Pulse Enable
Tip Strip: Enables injection pulse
Detail: When ON, the EPT Mode command to the PFI Driver module will be active for the specified duration.
When OFF, the command will be inactive, but the specified timing and duration will still be implemented.
Therefore, the timing of the adjacent pulses will remain the same whether the pulse is ON or OFF.

4.5.3 PFI Tab

PFI and LS Driver Setup
PFI and LS Driver Setup, the TMP parameters of this tab are not applicable. When
PFI Module Control tab of the
window. When the
PFI and LS Driver Setup, the EPT parameters of this tab are
PFI and LS Driver Setup
NI DIDS-2100 Series User Manual | © National Instruments | 105
EPT Mode is selected in the
window). The PFI Driver
PFI
TMP