Table of Contents
Advertisement
The external battery supply input terminals on the NI 9751 (DI Driver) and NI 9758 (PFI Driver) modules
are not reverse-voltage polarity protected. Connecting power to the module in reverse polarity will
damage the modules. This event is not covered by the warranty. Please refer to the
Polarity Notice
for a recommended solution for protecting a system from reverse battery polarity.
The DI Driver System requires external DC power to the following system components:
Component
cRIO-9066
NI 9751 Modules 1-4
NI 9758 Module
NI 9411 Module*
NI 9760 Module**
3.3.2.a, Power Supply Specifications for I/O Hardware
*The NI 9411 module only needs external power supplied to the screw-terminal block if 5V regulated output power is
required from the 15-pin D-Sub connector to an optical encoder. Do not connect external power to the 15-pin D-Sub.
**The NI 9760 module only needs external power supplied to the screw-terminal block if 5V regulated output power is
required from the 37-pin D-Sub connector to an optical encoder. Do not connect external power to the 37-pin D-Sub.
NI recommends the following power supply options for powering the system
components:
NI Part Number Model Number Input Voltage
783168-01
QS10.121
781095-01
PS-17
3.3.2.b, Power Supply Recommendations for the DI Driver System
The power supplies listed above are not included with the DI Driver System, but are available through National
Instruments. There are a few considerations for selecting the proper power supply system – specifically whether to
use a 12V power supply (QS10.121) or a 24V power supply (PS-17). NI recommends using a 24V power supply in
order to increase the efficiency of the DI Driver modules' internal boost supply. However, if an optional PFI Driver
module is used, and the associated actuators are not rated for 24V, then the lower 12V power supply should be
used.
DI Driver Systems with one or two DI Driver modules (DIDS-2103 and DIDS-2106) can typically be powered by a
single recommended supply listed above. DI Driver Systems with three or four DI Driver modules (DIDS-2109 and
DIDS-2112) should be powered by two identical supplies wired in parallel. Power supplies wired in parallel will create
42 | ni.com | NI DIDS-2100 Series User Manual
3.3.2 Powering the System
Warning:
Power
Terminal Label
V
BATT (0)
BATT (0)
Vsup
5-30V IN
Output Voltage
100-240 VAC
12-15 V
85-276 VAC
24-28 V
Ground
Voltage Range
Terminal Label
C
GND (9)
GND (9)
COM
GND
Output Current
15A
20A
Reverse Battery
Maximum
Required Power
9-30 V
25 W
9-32 V
75 W Each
9-32 V
75 W
5-30 V
1 W
5-30 V
2 W
Advertisement
Table of Contents
