Panasonic KX-TDA30 Features Manual page 33

*: This is applied only when a trunk call arrives on a DISA line but the line is busy at that time. Once the
call reaches the destination extension by using the DISA feature, the Intercept Routing feature of the
extension is used.
Different intercept destinations can be programmed for each time mode (day/lunch/break/night) (→ 2.2.4
Time Service).
[Available Intercept Destinations]
Wired Extension (PT/SLT/ISDN Extension/T1-OPX)
PS
Incoming Call Distribution Group
PS Ring Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analogue/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Other PBX Extension (TIE with no PBX Code)
Other PBX Extension (TIE with PBX Code)
Conditions
• Intercept Routing—Busy/DND on/off
Intercept Routing—Busy and Intercept Routing—DND can be enabled or disabled separately through
system programming.
If disabled, one of the following is activated depending on the trunk card type that a call arrives through:
a)
LCOT or T1 (LCOT/GCOT) Card: The incoming trunk call will ring at the original destination while
the caller hears a ringback tone.
b)
Other Trunk Cards: A busy tone will be sent to the caller.
• If the intercept destination cannot receive the call:
a)
Intercept Routing—No Answer: Intercept timer will restart at the original destination, until the call
is answered.
b)
Intercept Routing—Busy/DND: The call will be sent back to the original destination when the call
arrives through the LCOT or T1 (LCOT/GCOT) card. When the call arrives through other trunk
cards the caller will hear a busy tone.
• Idle Extension Hunting
If an extension is a member of an idle extension hunting group, calls to that extension will not be
redirected by Intercept Routing—Busy/DND. If the extension is busy or in DND mode, calls to that
extension will be redirected to the next extension in the idle extension hunting group.
Intercept Destination
1.1 Incoming Call Features
Availability
Feature Guide 33