Ip Multicast Dvmrp Tunnels Remove - 3Com 4007 Command Reference Manual

ip multicast dvmrp
tunnels remove
Layer 2
Switching
Modules
Multilayer
Switching
Modules
Deletes a DVMRP tunnel configuration (tunnel end point) from a
Multilayer Switching Module.
Valid Minimum Abbreviation
ip m d t r
Important Considerations
To remove a tunnel, specify its tunnel index number. Recall that this
number is different from the routing interface index number.
Reference the DVMRP tunnel summary display to verify the correct
index number prior to deleting a tunnel.
Removing a tunnel configuration (end point) from a Multilayer
Switching Module effectively disables the tunnel functionality, but be
sure to remove the associated tunnel configuration from the remote
system as well.
If you try to remove an IP interface in your module, and you have a
DVMRP tunnel defined on that interface, the module warns you with
an error message. Before you can remove the IP interface, you must
remove the DVMRP tunnel.
When you remove a tunnel, the module does not dynamically re-order
remaining tunnels in the DVMRP tunnel summary display. For
example, if you had three tunnels with tunnel index numbers 1, 2, and
3 and you then removed tunnel 2, the display lists the remaining
tunnels with their original tunnel index numbers (1 and 3, in this
example). The module assigns tunnel index 2 to the next new tunnel
that you define. After 2 is used, the module can assign tunnel index 4
for the next new tunnel, and so on.
Options
Prompt Description
Multicast Index number of the
tunnel index tunnel that you want to
remove
Possible Values
A valid DVMRP tunnel
index number
? (for a list of selectable
tunnel index numbers)
335
[Default]
–