Bridge Packetfilter Create Portgroup - 3Com 4007 Command Reference Manual

3com 4007: reference guide

Hide thumbs Also See for 4007:

Table of Contents

bridge packetFilter

create portGroup

Creates the portGroup (

Multilayer Switching Modules.

Valid Minimum Abbreviation

Important Considerations

The portGroup (rejdiffportgroup) packet filter rejects a frame if the

destination and source ports are not in the same group.

Creating a hardware filter means that the code for the filter is copied

from firmware into non-volatile memory.

To verify that the filter has been created, use the

packetFilter list

filter, use the

bridge PacketFilter display

The module only creates the packet filter definition. You must still

assign ports and masks to port groups, as described for "bridge

packetFilter portGroup create" later in this chapter, and assign the

standard filter to ports and filtering paths, as described for "bridge

packetFilter assign" later in this chapter.

At present, portGroup is the only filter supported in hardware.

) standard hardware filter on

rejdiffportgroup

command. To see the contents of the portGroup