3Com 4007 Command Reference Manual page 189

bridge vlan detail 189
Bridge VLAN Define Example
This example shows the steps necessary to define a protocol-based VLAN
for IPX 802.3 on a Multilayer Switching Module. In this example, only the
backplane port (port 13) of the module has IEEE 802.1Q tagging; the
front-panel ports in this VLAN are not tagged. Because you have tagged
the module's backplane port, you must also tag the corresponding switch
fabric module port of the switch fabric module for that VLAN.
CB9000@slot3.1 [12-E/FEN-TX-L3] (bridge/vlan): define
Enter VID (2-4094) [5]: 5
Select bridge ports (1-13|all|?): 1-3,13
Enter protocol suite
(IP,IPX,Apple,XNS,DECnet,SNA,Vines,X25,NetBEUI,unspecified,
IPX-II,IPX-802.2,IPX-802.3): IPX-802.3
Enter protocol suite ('q' to quit)
(IP,Apple,XNS,DECnet,SNA,Vines,X25,NetBEUI,IPX-II,IPX-802.2,
IPX-802.3): q
Configure per-port tagging? (n,y) [y]: y
Enter port 1 tag type (none,802.1Q): none
Enter port 2 tag type (none,802.1Q): none
Enter port 3 tag type (none,802.1Q): none
Enter port 13 tag type (none,802.1Q): 802.1Q
Enter VLAN Name {?} [ ]: IPX1