3Com 4007 Command Reference Manual page 188

188 C 10: V
HAPTER IRTUAL
LAN (VLAN )
S S
Prompt Description
Per-port Whether you want to
tagging configure IEEE 802.1Q VLAN
tagging. You are prompted to
answer for each port that you
selected.
Tag type Whether you want to
configure no tagging or IEEE
802.1Q tagging (the VID) for
each port.
VLAN name Unique, user-defined name
that identifies members of the
(for VLANs
VLAN. If you use spaces, put
other than
quotation marks around the
the default)
VLAN name.
Procedure
1 Enter the VLAN identification (VID) number in the range 2 – 4094.
2 Select the bridge ports.
3 Select one or more protocol suites.
If you select an IP protocol suite, proceed with step 4. If you did not
choose an IP protocol suite for this interface, proceed to step 5.
4 Specify whether you want to specify Layer 3 address information (
The default is . Specify
y
interfaces for this VLAN using
Chapter 12.) If you still want to specify Layer 3 address information for an
IP VLAN:
a Enter for Layer 3 addressing.
y
b Enter the Layer 3 network address.
c Enter the Layer 3 subnet mask. To accept the default or current value
in brackets [ ], press Return or Enter.
5 Specify whether you want per-port tagging (
6 If you specified per-port tagging, enter the tag type for the indicated port
( or ).
none 802.1Q
7 If you have defined more than one port, you are prompted again for a tag
type for each port.
8 Enter the VLAN name.
Possible Values
y (yes)
n (no)
none
802.1Q
Up to 32 ASCII
characters or
spaces
if possible and instead define multiple IP
n
ip interface define
n
[Default]
y
none
–
n
commands. (See
or ). The default is .
y y
or ).
y