Power On The Router - Juniper T320 Quick Start Manual

Power On the Router

Copyright © 2015, Juniper Networks, Inc.
Verify that the power supplies are fully inserted in the chassis and that the captive
1.
screws on their faceplates are tightened.
Verify that each positive (+) source DC power cable lug is connected to the correct
2.
return terminal (labeled
(–) power cable lug is connected to the correct input terminal (labeled
Verify that an external management device is connected to one of the Routing Engine
3.
ports on the CIP (
AUXILIARY
Turn on the power to the external management device.
4.
Switch on the external circuit breakers to provide voltage to the DC power source
5.
cable leads.
Turn the switch on one of the power supplies
6.
supply faceplate. If the power supply is correctly installed and is functioning properly,
the lights steadily.
DC OK LED
Repeat Step 5 for the remaining power supply.
7.
On the management device, monitor the startup process to verify that the system
8.
has booted properly.
) on the power supply faceplate, and that each negative
RTN
, , or
CONSOLE ETHERNET
and observe the LED on the power
ON
Power On the Router
).
-48V
).
21