Step 7: Perform Initial Software Configuration; Entering Configuration Mode; Configuring User Accounts And Passwords - Juniper T320 Quick Start Manual

T320 Core Router Quick Start

Step 7: Perform Initial Software Configuration

Entering Configuration Mode

Configuring User Accounts and Passwords

22
The T320 Core Router is shipped with the Junos OS preinstalled and ready to be configured
when the T320 router is powered on. These procedures connect a router to the network
but do not enable it to forward traffic. For complete information about enabling the router
to forward traffic, including examples, see the Junos OS configuration guides.
NOTE: These procedures enable you to use the management Ethernet port
labeled ETHERNET
attached to the
For more information about the commands in this procedure see the Junos OS
Administration Library for Routing Devices.
Entering Configuration Mode on page 22
1.
Configuring User Accounts and Passwords on page 22
2.
Configuring System Attributes on page 23
3.
Committing the Configuration on page 24
4.
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see authentication.
Add a password to the root administration user account. Enter a clear-text password.
1.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
on the CIP. For the initial configuration, use a device
port on the CIP.
CONSOLE
Copyright © 2015, Juniper Networks, Inc.