Figure 130 Maintenance > Sys Op Mode > General: Ap; Table 99 Maintenance > Sys Op Mode > General - ZyXEL Communications ZyXEL NBG334W User Manual

Figure 130 Maintenance > Sys Op Mode > General: AP
• In AP Mode all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port labeled WAN.
There is no WAN port.
• The DHCP server on your device is disabled. In AP mode there must be a device with a
DHCP server on your network such as a router or gateway which can allocate IP
addresses.
The IP address of the device on the local network is set to 192.168.1.1.
The following table describes the labels in the General screen.
Table 99 Maintenance > Sys OP Mode > General
LABEL
System Operation Mode
Router
Access Point
Apply
Reset
If you select the incorrect System Operation Mode you cannot connect to the
Internet.
NBG334W User's Guide
DESCRIPTION
Select Router if your device routes traffic between a local network and another
network such as the Internet. This mode offers services such as a firewall or
bandwidth management.
Select Access Point if your device bridges traffic between clients on the same
network.
Click Apply to save your settings.
Click Reset to return your settings to the default (Router)
Chapter 23 Sys Op Mode
217