Front Panel Leds; Rear Panel; Turning On The Vsg; Figure 7 Rear Panel - ZyXEL Communications Vantage Service Gateway VSG-1200 V2 User Manual

VSG-1200 V2 User's Guide

2.2.2 Front Panel LEDs

The following table describes the LEDs on the front panel. When turned on, all LEDs are
green unless otherwise specified.

Table 1 Front Panel LEDs

LED STATUS
PWR On
Off
SYS On
Blinking
Off
LAN or WAN
10 On
Blinking
Off
100 On
Blinking
Off

2.2.3 Rear Panel

The power socket, the fan and a ventilation hole are located on the rear panel as shown next.
Note: Do NOT block the ventilation hole.

Figure 7 Rear Panel

2.2.4 Turning on the VSG

Connect the female end of the supplied power cord to the power socket on the back of the
VSG and the male end to an appropriate power source.
When the power source is turned on, the PWR LED on the front panel turns on.
41
DESCRIPTION
The VSG is receiving power.
The VSG is not receiving power.
The system is functioning normally.
The system is not functioning properly.
The system is not ready or has failed.
The port is connected at 10 Mbps.
The port is receiving or sending data.
The port is not connected to an Ethernet device.
The port is connected at 100 Mbps.
The port is receiving or sending data.
The port is not connected to an Ethernet device.
Chapter 2 Hardware Installation and Connection