Hardware Installation & Initial Setup
This chapter shows you how to connect the hardware and perform the initial setup.
2.1
Front Panel LEDs and Back Panel Ports
2.1.1 Front Panel LEDs
The LEDs on the front panel indicate the operational status of the ZyWALL.
The following table describes the LED functions:
LEDs
Function Indicator
PWR
Power
SYS
System
10M LAN
LAN
100M LAN
Hardware Installation & Initial Setup
Figure 2-1 Front Panel
Table 2-1 LED functions
Active
Status
Green
On
Off
On
Flashing
Green
Off
On
Flashing
Orange
Off
On
Flashing
ZyWALL 10 Internet Security Gateway
Description
The power adapter is connected to the ZyWALL.
The system is not ready or failed.
The system is ready and running.
The system is rebooting.
The 10M LAN is not connected.
The ZyWALL is connected to a 10M LAN.
The 10M LAN is sending/receiving packets.
The 100M LAN is not connected.
The ZyWALL is connected to a 100Mbps LAN.
The 100M LAN is sending/receiving packets.
Chapter 2
2-1