Boot Module Commands; Figure 10-12 Command Mode; Figure 10-13 Boot Module Commands - ZyXEL Communications Prestige 641 User Manual

Prestige 641 ADSL Internet Access Router
Copyright (c) 1994 - 1999 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
wan
ipx

10.8 Boot module commands

Prestige boot module commands with accompanying explanations are shown in the following table. For
ATBAx, x denotes the number preceding the colon to give the console port speed following the colon in the
list of numbers that follows; e.g. ATBA3 will give a console port speed of 9.6 Kbps. ATSE displays the
seed that is used to generate a password to turn on the debug flag in the firmware. The ATSH command
shows product related information such as boot module version, vendor name, product model, RAS code
revision, etc.
======= Debug Command Listing =======
AT
ATHE
ATBAx
ATENx,(y)
ATENx,(y)
ATSE
ATTI(h,m,s)
ATDA(w,y,m,d) change system date to week year/month/day or show current date
ATDS
ATDT
ATDUx,y
ATRBx
ATRWx
ATRLx
ATGO(x)
ATGR
ATGT
ATRTw,x,y(,z) RAM test level w, from address x to y (z iterations)
ATSH
ATDOx,y
ATUR
ATUR3
10-12
Enter Menu Selection Number: 8
exit device
ip ppp
hdap

Figure 10-12 Command mode

just answer OK
print help
change baudrate. 1:38.4k, 2:19.2k, 3:9.6k 4:57.6k 5:115.2k
set BootExtension Debug Flag (y=password)
set BootExtension Debug Flag (y=password)
show the seed of password generator
change system time to hour:min:sec or show current time
dump RAS stack
dump Boot Module Common Area
dump memory contents from address x for length y
display the 8-bit value of address x
display the 16-bit value of address x
display the 32-bit value of address x
run program at addr x or boot ZyNOS
boot ZyNOS
run Hardware Test Program
dump manufacturer related data in ROM
download from address x for length y to PC via XMODEM
upload RAS code to flash ROM
upload RAS configuration file

Figure 10-13 Boot module commands

ether
bridge
System Maintenance