Ipx Remote Node Setup; Figure 6-5 Menu 11.3 - Remote Node Novell Ipx Options (For Llc-Based Multiplexing) - ZyXEL Communications Prestige 641 User Manual

Prestige 641 ADSL Internet Access Router

6.4.1 IPX Remote Node Setup

Follow the procedure in Chapter 5 to configure the protocol-independent parameters in Menu 11.1 -
Remote Node Profile. For the IPX-specific parameters in Menu 11.3 - Remote Node Network Layer
Options follow the instructions below.
Step 1. In Menu 11.1, make sure IPX is among the protocols in the Route field. (The Route field should
display Route = IPX or Route = IP + IPX.)
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, then press the space bar to select Yes and
press [Enter] to open Menu 11.3 - Network Layer Options.
VPI/VCI (RFC1483 LLC/PPP/ENET ENCAP) :
VPI #= 1
VCI #= 1
IP Options:
IP Address Assignment= Static
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A

Figure 6-5 Menu 11.3 - Remote Node Novell IPX Options (for LLC-based multiplexing)

6-6
Menu 11.3 - Remote Node Network Layer Options
Enter here to CONFIRM or ESC to CANCEL:
IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Ethernet Addr Timeout(min)= N/A
IPX Configuration