Hardware Installation & Initial Setup
2.1
Front Panel LEDs OF P641
The LED indicators on the front panel indicate the operational status of the Prestige 641. The table below
the diagram describes the LED functions:
ZyXEL
The PWR (power) LED is on when power is applied to the Prestige.
PWR
SYS
A steady on SYS (system) LED indicates the Prestige is on and functioning properly
while an off SYS LED indicates the system is not ready or a malfunction. The
system is rebooting when the SYS LED is blinking.
LAN 10M
A steady green light indicates a 10Mb Ethernet connection. The LED blinks when
data is being sent/received.
LAN 100M
A steady orange light indicates a 100Mb Ethernet connection. The LED will blink
when data is being sent/received.
ADSL
The ADSL LED is on when the Prestige is connected successfully to a DSLAM. The
LED blinks when data is being sent/received. The LED is off when the link is down.
2.2
Prestige 641 Rear Panel and Connections
The following figure shows the rear panel connectors of your Prestige.
Hardware Installation & Setup
Prestige 641 ADSL Internet Access Router
PWR
SYS
10M
Figure 2-1 Prestige 641 Front Panel.
Table 2-1 Front Panel LED Description
This chapter describes the physical features of the
Prestige and how to make the cable connections
LAN
100M
ADSL
Chapter 2
.
PRESTIGE
600
SERIES
2-1