Applying A Filter; Ethernet Traffic; Remote Node Filters; Figure 8-7 Filtering Ethernet Traffic - ZyXEL Communications Prestige 641 User Manual

Prestige 641 ADSL Internet Access Router
8.5

Applying a Filter

This section shows you where to apply the filter(s) after you design it (them).

8.5.1 Ethernet traffic

You seldom need to filter Ethernet traffic; however, the filter sets may be useful to block certain packets,
reduce traffic and prevent security breaches. Go to Menu 3.1 (shown below) and enter the number(s) of the
filter set(s) that you want to apply as appropriate. You can choose up to four filter sets (from twelve) by
entering their numbers separated by commas, e.g., 3, 4, 6, 11.

8.5.2 Remote Node Filters

Go to Menu 11.5 (shown below) and enter the number(s) of the filter set(s) as appropriate. You can cascade
up to four filter sets by entering their numbers separated by commas.
8-12
Menu 3.1 - General Ethernet Setup
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Press ENTER to Confirm or ESC to Cancel:

Figure 8-7 Filtering Ethernet traffic

Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters

Figure 8-8 Filtering Remote Node traffic

=
Filter Configuration