Restore Using Ftp Session Example; Figure 183 Telnet Into Menu 24.6; Figure 184 Restore Using Ftp Session Example - ZyXEL Communications P-660H-D Series User Manual

Figure 183 Telnet into Menu 24.6

To transfer the firmware and configuration file to your workstation, follow
the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your Prestige. Then type "root" and SMT
password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-0 is the
remote file name on the Prestige. This restores the configuration
your Prestige.
4. The system reboots automatically after a successful file transfer
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your Prestige manual.
1 Launch the FTP client on your computer.
2 Enter "
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "
6 Find the "
7 Use "
put
config.rom rom-0
to the Prestige. See earlier in this chapter for more information on filename conventions.
8 Enter "
successful restore process.

31.3.2 Restore Using FTP Session Example

Figure 184 Restore Using FTP Session Example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 31.2.5 on page 279
over WAN.
Chapter 31 Firmware and Configuration File Maintenance
Menu 24.6 -- System Maintenance - Restore Configuration
Press ENTER to Exit:
", followed by a space and the IP address of your Prestige.
open
" to set transfer mode to binary.
bin
" file (on your computer) that you want to restore to your Prestige.
rom
" to transfer files from the Prestige to the computer, for example, "
" transfers the configuration file "
" to exit the ftp prompt. The Prestige will automatically restart after a
quit
to read about configurations that disallow TFTP and FTP
P-660R/H-D Series User's Guide
put
" on your computer
config.rom
to
282