Firmware Upgrade; Table 66 Diagnostic: Dsl Line - ZyXEL Communications P-660H-D Series User Manual

P-660R/H-D Series User's Guide
The following table describes the fields in this screen.

Table 66 Diagnostic: DSL Line

LABEL
Reset ADSL
Line
ATM Status
ATM Loopback
Test
Upstream Noise
Margin
Downstream
Noise Margin
Back

17.6 Firmware Upgrade

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with
a.bin extension, for example, "Prestige.bin". The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot. See
Only use firmware for your device's specific model. Refer to the label on the bottom of your
device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.
183
Click this button to reinitialize the ADSL line. The large text box above then displays
the progress and results of this operation, for example:
"Start to reset ADSL
Loading ADSL modem F/W...
Reset ADSL Line Successfully!"
Click this button to view ATM status.
Click this button to start the ATM loopback test. Make sure you have configured at
least one PVC with proper VPIs/VCIs before you begin this test. The Prestige sends
an OAM F5 packet to the DSLAM/ATM switch and then returns it (loops it back) to
the Prestige. The ATM loopback test is useful for troubleshooting problems with the
DSLAM and ATM network.
Click this button to display the upstream noise margin.
Click this button to display the downstream noise margin.
Click this button to go back to the main Diagnostic screen.
Chapter 31 on page 276
DESCRIPTION
for upgrading firmware using FTP/TFTP commands.
Chapter 17 Maintenance