ZyXEL Communications P-660H-D Series User Manual page 367

Table 130 Firewall Commands (continued)
FUNCTION
Delete
Appendix I Firewall Commands
COMMAND
config edit firewall set <set
#> rule <rule #> destaddr-
range <start ip address> <end
ip address>
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#>
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#>
config delete firewall e-mail
config delete firewall attack
config delete firewall set
<set #>
config delete firewall set
<set #> rule<rule #>
P-660R/H-D Series User's Guide
DESCRIPTION
This command sets a rule to have the Prestige
check for traffic going to this range of
addresses.
This command sets a rule to have the Prestige
check for TCP traffic with this destination
address. You may repeat this command to
enter various, non-consecutive port numbers.
This command sets a rule to have the Prestige
check for TCP traffic with a destination port in
this range.
This command sets a rule to have the Prestige
check for UDP traffic with this destination
address. You may repeat this command to
enter various, non-consecutive port numbers.
This command sets a rule to have the Prestige
check for UDP traffic with a destination port in
this range.
This command removes all of the settings for
e-mail alert.
This command resets all of the attack
response settings to their defaults.
This command removes the specified set from
the firewall configuration.
This command removes the specified rule in a
firewall configuration set.
366