Figure 111 Menu 11.1 Remote Node Profile; Table 79 Menu 11.1 Remote Node Profile - ZyXEL Communications P-660H-D Series User Manual

Figure 111 Menu 11.1 Remote Node Profile

Rem Node Name= MyISP
Active= Yes
Encapsulation= RFC 1483
Multiplexing= LLC-based
Service Name= N/A
Incoming:
Rem Login= N/A
Rem Password= N/A
Outgoing:
My Login= N/A
My Password= N/A
Authen= N/A
Press ENTER to Confirm or ESC to Cancel:
In Menu 11.1 – Remote Node Profile, fill in the fields as described in the following table.

Table 79 Menu 11.1 Remote Node Profile

FIELD
Rem Node Name
Active
Encapsulation
Multiplexing
Service Name
Incoming:
Rem Login
Rem Password
Outgoing:
My Login
My Password
Authen
Chapter 23 Remote Node Configuration
Menu 11.1 - Remote Node Profile
DESCRIPTION
Type a unique, descriptive name of up to eight characters for this node.
Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to
deactivate this node. Inactive nodes are displayed with a minus sign –" in SMT
menu 11.
PPPoA refers to RFC-2364 (PPP Encapsulation over ATM Adaptation Layer 5).
If RFC-1483 (Multiprotocol Encapsulation over ATM Adaptation Layer 5) of ENET
ENCAP are selected, then the Rem Login, Rem Password, My Login, My
Password and Authen fields are not applicable (N/A).
Press [SPACE BAR] and then [ENTER] to select the method of multiplexing that
your ISP uses, either VC-based or LLC-based.
When using PPPoE encapsulation, type the name of your PPPoE service here.
Type the login name that this remote node will use to call your Prestige. The login
name and the Rem Password will be used to authenticate this node.
Type the password used when this remote node calls your Prestige.
Type the login name assigned by your ISP when the Prestige calls this remote
node.
Type the password assigned by your ISP when the Prestige calls this remote
node.
This field sets the authentication protocol used for outgoing calls. Options for this
field are:
CHAP/PAP – Your Prestige will accept either CHAP or PAP when requested by
this remote node.
CHAP – accept CHAP (Challenge Handshake Authentication Protocol) only.
PAP – accept PAP (Password Authentication Protocol) only.
P-660R/H-D Series User's Guide
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= N/A
Telco Option:
Allocated Budget(min)= N/A
Period(hr)= N/A
Schedule Sets= N/A
Nailed-Up Connection= N/A
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= N/A
212