Restore Using Ftp Session Example; Restore Via Console Port; Figure 327 Restore Using Ftp Session Example; Figure 328 System Maintenance: Restore Configuration - ZyXEL Communications ZyWall 35 User Manual

40.4.2 Restore Using FTP Session Example

Figure 327 Restore Using FTP Session Example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 40.3.5 on page 522
over WAN.

40.4.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next.
Procedures using other serial communications programs should be similar.
1 Display menu 24.6 and enter "y" at the following screen.

Figure 328 System Maintenance: Restore Configuration

2 The following screen indicates that the Xmodem download has started.

Figure 329 System Maintenance: Starting Xmodem Download Screen

3 Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
Chapter 40 Firmware and Configuration File Maintenance
to read about configurations that disallow TFTP and FTP
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...CCCCCCCCC
ZyWALL 35 User's Guide
527