Remote Node Configuration; Remote Node Setup Overview; Remote Node Setup; Remote Node Profile - ZyXEL Communications P-660H-D Series User Manual

Remote Node Configuration

This chapter covers remote node configuration.

23.1 Remote Node Setup Overview

This section describes the protocol-independent parameters for a remote node. A remote node
is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. When you use menu 4 to set up
Internet access, you are configuring one of the remote nodes.
You first choose a remote node in Menu 11- Remote Node Setup. You can then edit that
node's profile in menu 11.1, as well as configure specific settings in three submenus: edit IP
and bridge options in menu 11.3; edit ATM options in menu 11.6; and edit filter sets in menu
11.5.
23.2

Remote Node Setup

This section describes the protocol-independent parameters for a remote node.
23.2.1

Remote Node Profile

To configure a remote node, follow these steps:
1 From the main menu, enter 11 to display Menu 11 - Remote Node Setup.
2 When menu 11 appears, as shown in the following figure, type the number of the remote
node that you want to configure.
Chapter 23 Remote Node Configuration
P-660R/H-D Series User's Guide
C
H A P T E R
2 3
210