My Wan Addr Sample Ip Addresses - ZyXEL Communications P-660H-D Series User Manual

P-660R/H-D Series User's Guide
Table 80 Menu 11.3 Remote Node Network Layer Options (continued)
FIELD
Metric
Private
RIP Direction
Version
Multicast
IP Policies
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

23.3.1 My WAN Addr Sample IP Addresses

The following figure uses sample IP addresses to help you understand the field of My WAN
Addr in menu 11.3. My WAN Addr indicates the local Prestige WAN IP (172.16.0.1 in the
following figure) while Rem IP Addr indicates the peer WAN IP (172.16.0.2 in the following
figure).
215
DESCRIPTION
The metric represents the cost of transmission for routing purposes. IP routing uses
hop count as the cost measurement, with a minimum of 1 for directly connected
networks. Type a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
This determines if the Prestige will include the route to this remote node in its RIP
broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. If
No, the route to this remote node will be propagated to other hosts through RIP
broadcasts.
Press [SPACE BAR] and then [ENTER] to select the RIP Direction. Options are Both,
In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-1,
RIP-2B or RIP-2M.
IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and None disables
IGMP.
You can apply up to four IP Policy sets (from 12) by typing in their numbers separated
by commas. Configure the filter sets in menu 25 first (see
and then apply them here.
" to save your configuration, or press [ESC] at any time to cancel.
Chapter 34 on page
Press ENTER to Confirm
Chapter 23 Remote Node Configuration
298)