Jrr200 Chassis; Jrr200 Route Reflector Chassis Front Panel; Figure 1: Jrr200 Route Reflector Front Panel; Table 3: Jrr200 Route Reflector Components On The Front Panel - Juniper JRR200 Hardware Manual

JRR200 Route Reflector Hardware Guide

JRR200 Chassis

JRR200 Route Reflector Chassis Front Panel

18
DC power supply units
Fan trays
JRR200 Route Reflector Chassis Front Panel on page 18
JRR200 Route Reflector Chassis Rear Panel on page 20
JRR200 Route Reflector Physical Specifications on page 21
Figure 1 on page 18 shows the front panel of the JRR200 route reflector.

Figure 1: JRR200 Route Reflector Front Panel

1 2
5 6 7
Table 3 on page 18 lists the components on the front panel of the JRR200 route reflector.

Table 3: JRR200 Route Reflector Components on the Front Panel

Number Component
1 Management port
2 USB ports
3 HA ports
4 SFP+ ports
5 LEDs
6 Console port
7 button
RESET
3 4
Description
Gigabit Ethernet port to connect to the device over the
network.
Two USB 2.0 ports that accept a USB storage device.
The two HA ports are not supported on the JRR200 route
reflector.
Eight 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ ports for
network traffic.
Indicate component and system status at a glance.
Connects a laptop to the JRR200 route reflector for CLI
management. The port uses an RJ-45 serial connection, is
configured as DTE, and supports the RS-232 (EIA-232)
standard.
Returns the JRR200 route reflector to the factory-default
configuration.
Copyright © 2018, Juniper Networks, Inc.