Ac Power Electrical Safety Guidelines; Figure 21: Placing A Component Into An Antistatic Bag - Juniper JRR200 Hardware Manual

JRR200 Route Reflector Hardware Guide

AC Power Electrical Safety Guidelines

98

Figure 21: Placing a Component into an Antistatic Bag

CAUTION
ELECTROSTATIC
SENSITIVE
DEVICES
DO NOT OPEN OR HANDLE
EXCEPT AT A
STATIC-FREE WORKSTATION
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6
can get electrostatically charged. To dissipate this charge, always ground
the cables to a suitable and safe earth ground before connecting them to the
system.
CAUTION: For devices with AC power supplies, an external surge protective
device (SPD) must be used at the AC power source.
The following electrical safety guidelines apply to AC-powered devices:
Note the following warnings printed on the device:
"CAUTION: THIS UNIT HAS MORE THAN ONE POWER SUPPLY CORD. DISCONNECT
ALL POWER SUPPLY CORDS BEFORE SERVICING TO AVOID ELECTRIC SHOCK."
"ATTENTION: CET APPAREIL COMPORTE PLUS D'UN CORDON D'ALIMENTATION.
AFIN DE PRÉVENIR LES CHOCS ÉLECTRIQUES, DÉBRANCHER TOUT CORDON
D'ALIMENTATION AVANT DE FAIRE LE DÉPANNAGE."
AC-powered devices are shipped with a three-wire electrical cord with a grounding-type
plug that fits only a grounding-type power outlet. Do not circumvent this safety feature.
Equipment grounding must comply with local and national electrical codes.
You must provide an external certified circuit breaker (2-pole circuit breaker or 4-pole
circuit breaker based on your device) rated minimum 20 A in the building installation.
The power cord serves as the main disconnecting device for the AC-powered device.
The socket outlet must be near the AC-powered device and be easily accessible.
For devices that have more than one power supply connection, you must ensure that
all power connections are fully disconnected so that power to the device is completely
Copyright © 2018, Juniper Networks, Inc.