Table of Contents
Advertisement
INTUITY Messaging Solutions Release 5 Migration Procedures
Connecting the External Tape Drive
22
3. Turn off the system power and connect the external tape drive to
the external SCSI connection on the INTUITY AUDIX system.
4. Continue with Connecting the External Tape Drive (page 22).
!
WARNING:
Damage from electrostatic discharge is possible. For more
information, see Protecting against Damage from Electrostatic
Discharge (page xiii) in About This Book (page vii).
To connect the external tape drive:
1. Remove the existing SCSI cable from the back of the external
tape drive.
2. Turn off the external drive's power switch.
3. Find the SCSI port on the INTUITY AUDIX system.
The SCSI port is one of three types shown in the connector
drawings. It will most likely be found at or near the standard
location shown in MAPs and SCSI Port Locations (page 60) or
MAP/100P SCSI Connection (Front of System) (page 61).
4. If one exists, remove the external SCSI terminator from the
system's external SCSI connection.
5. Determine which of three cables from the migration kit connects
the external SCSI connector to the external cartridge drive.
See SCSI Cables for the INTUITY AUDIX System (page 62).
6. Connect the SCSI 2 end of the cable to the back of the external
tape drive.
7. Attach the other end of the cable to the external SCSI connector
on the INTUITY AUDIX system.
8. Turn on the tape drive power switch.
9. Continue with Completing the Data Transfer (page 23).
585-313-118 Issue 4
June 2002
Advertisement
Table of Contents
