Table of Contents
Advertisement
Connecting Release 4.0
June 2002
9. Locate the short, flat SCSI cable from the migration kit.
Complete Step a through Step D to install the cable:
a. Position the cable with the red edge down. Route the cable
into the front of the circuit pack, through the opening left by
the removed tape drive.
b. Attach the cable to the tape drive connector on the Alarm
Board.
c. Connect one end of the long cable to the external tape drive.
Both the long cable and external tape drive can be found in
the migration kit.
d. Connect the other end of the long cable to the short cable that
is connected to the Alarm Board.
10. Connect AC power to the external tape drive and turn it on.
11. Insert the 525 MB tape from the migration kit into the drive.
Note:
Note:
Make sure that the tape you insert is not write protected.
12. Insert the DEFINITY AUDIX back into the host switch and allow
the system to boot up.
13. Return to the Migration Checklist (page 2).
To connect the external tape drive to DEFINITY AUDIX Release 4.0 for
the backup:
1. Log on to the DEFINITY AUDIX machine using the craft login.
The system displays the DEFINITY AUDIX Command Prompt
screen.
2. Enter reset system shutdown to shut down the DEFINITY
AUDIX.
3. Verify that the DEFINITY AUDIX is shut down and then remove
it from the host switch.
!
CAUTION:
Be careful when handling the system. The power cable to
the magneto-optical (MO) drive is fragile and can easily
break.
585-313-118 Issue 4
Migrating from DEFINITY AUDIX
13
Advertisement
Table of Contents
