Table of Contents
Advertisement
INTUITY Messaging Solutions Release 5 Migration Procedures
MAP/5P, MAP/5PV3, and MAP/5PV4 Responses
20
!
CAUTION:
Only use this procedure if you are migrating to a MAP/5P,
MAP/5PV3, or MAP/5PV4. Otherwise, go to MAP/40P or
MAP/100P Responses (page 21) and follow that procedure.
If you are transferring the data to a MAP/5P, MAP/5PV3, or MAP/5PV4,
the system displays the following message:
Have you installed the SCSI card from the
migration kit? (y or n)
1. Enter n
The system displays this message:
Do you have the migration kit? (y or n)
!
WARNING:
Damage from electrostatic discharge is possible. For more
information, see Protecting against Damage from Electrostatic
Discharge (page xiii) in About This Book (page vii).
2. Enter y
The system displays this message:
Install the SCSI card and attach the
external tape drive according to the
documentation. Press enter when you are
ready to shutdown the system.
3. Press ENTER.
The system displays a number of status messages until the
following message is displayed:
Press any key to reboot...
4. When the system displays the "reboot" message, turn off the
system power.
5. Remove the dress cover from the system. For more information,
see the Getting Inside the MAP/5P and MAP/5PV3 or Getting
Inside the MAP/5PV4 information on the INTUITY Messaging
Solutions Release 5 Documentation for Technicians CD-ROM.
6. Remove the SCSI interface circuit card from the reusable
migration kit and from the static-reducing bag.
See SCSI Interface Circuit Card (page 57).
585-313-118 Issue 4
June 2002
Advertisement
Table of Contents
