Table of Contents
Advertisement
MAP/40P or MAP/100P Responses
June 2002
7. Do one of the following:
n
If the new system is a MAP/5PV3, install the circuit card in
PCI slot 1, the uppermost slot within the cabinet. See
MAP/5P and MAP/5PV3 PCI Slot Location (page 58) for the
location of PCI slot 1.
n
If the new system is a MAP/5PV4, install the circuit card in
the shared PCI slot 2/ISA slot 1. This will require removing
the remote maintenace circuit card and then reinstalling the
remote maintenace circuit card when the data transfer is
complete. See MAP/5PV4 PCI/ISA Slot Locations (page 59)
for the location of the shared PCI slot 2/ISA slot 1.
8. Install and tighten the circuit card retaining screw.
Note:
Note:
Leave the dress cover off the system until the data transfer is
verified. You can then remove the SCSI interface card and
replace the dress cover. If you are upgrading to a MAP/5PV4
system, you will then also have to reinstall the remote
maintenace circuit card.
9. Continue with Connecting the External Tape Drive (page 22).
If you are transferring the data to a MAP/40P or a MAP/100P, the system
displays the following message:
The external tape drive was not found to be
attached.
Do you have the migration kit? (y or n)
1. Enter y
The system displays the following message:
Attach the external tape drive according to
the documentation. Press enter when you are
ready to shutdown the system.
2. Press ENTER.
The system displays a number of status messages until the
following message is displayed:
Press any key to reboot...
585-313-118 Issue 4
Migrating from DEFINITY AUDIX
21
Advertisement
Table of Contents
