Replacing The Air Filter On The Jsa7500 Appliance - Juniper JSA1500 Hardware Manual

Juniper Secure Analytics Hardware Guide
Related
Documentation

Replacing the Air Filter on the JSA7500 Appliance

Related
Documentation
126
Engage the fan lever to secure the fan in place.
9.
Close the fan lid and tighten the screws to secure it in the chassis.
10.
Field-Replaceable Units on the JSA Appliance on page 123
Replacing the Air Filter on the JSA7500 Appliance on page 126
Replacing an AC Power Supply on the JSA Appliance on page 127
Replacing AC Power Supply Cables on the JSA Appliance on page 127
Replacing a DC Power Supply on the JSA Appliance on page 128
Replacing DC Power Supply Cables on the JSA Appliance on page 129
The JSA7500 ships with a front bezel with air filter to provide optimum cooling to the
appliance.
CAUTION: Always keep the air filter in place while the JSA7500 appliance is
operating. Running the appliance without the air filter in place could cause
of small bits of dirt or other materials could be blown into the appliance. This
could damage the appliance components.
Perform the following steps to remove and install the air filter for JSA7500:
To remove the air filter:
1.
a. Attach an ESD grounding strap to your bare wrist and connect the strap to the ESD
point on the chassis.
b. Loosen the captive screws on the air filter cover.
c. Remove the air filter cover.
To install the air filter:
2.
a. Keep the air filter straight on the chassis.
b. Align the captive screws of the air filter cover with the mounting holes on the
chassis.
c. Tighten the captive screws on the air filter cover.
JSA7500 Front Panel on page 31
Field-Replaceable Units on the JSA Appliance on page 123
Replacing the Fan on the JSA Appliance on page 124
Copyright © 2018, Juniper Networks, Inc.