CHAPTER 17
Installing the JSA Appliance
Installing the JSA Hardware
Copyright © 2018, Juniper Networks, Inc.
Installing the JSA Hardware on page 103
Front-and-Rear-Mounting the JSA Appliance Flush to a Rack on page 104
Front-and-Rear-Mounting the JSA Appliance Recessed in a Rack on page 105
Front-and-Rear-Mounting the JSA7500 in a 4-Post Sliding Rail Rack on page 106
Mid-Mounting the JSA Appliance in a Two-Post Rack on page 109
Installing the CNA Module on the JSA1500 Appliance on page 110
Place the shipping container on a flat surface and carefully remove the hardware
components.
To install the Juniper Secure Analytics (JSA) appliance:
Mount the JSA appliance in your server rack using the attached mounting brackets.
1.
Plug the power cord into the AC receptacle on the rear panel. See
2.
If your JSA contains two power supplies, plug a power cord into each of the AC
receptacles.
Figure 18: JSA1500 Back Panel
1—
Cooling fans
2—
Power switch
Plug the other end of the power cord into a wall socket.
3.
Figure 18 on page
3—
Redundant power supply slot
4—
Power supply
103.
103