Figure 28: Jsa1500 With The Cna Card Inserted - Juniper JSA1500 Hardware Manual

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.

Figure 28: JSA1500 with the CNA Card Inserted

1— Empty
2— Hard drive
3— IOC expansion slot with 2-port 10G CNA
module installed
4— IOC expansion slot
5— Network ports
Power on the JSA1500 unit and watch it boot on the serial console.
4.
Verify that the link and activity LED on the new 2-port 10G CNA module light up when
5.
you connect the ports to your Ethernet switch with a duplex multi mode LC/LC MMF
fiber optic cable.
Log in to the admin console. You should now see four more Ethernet interfaces appear
6.
as 2-5. The four ports are labeled 0, 1, 2, and 3 and should map to Ethernet interfaces
as follows (default in Linux):
0 = eth0
1 = eth1
2 = eth2
3 = eth3
Connecting to a Management Device on page 100
Grounding the JSA7500 Appliance on page 97
Connecting JSA to a DC Power Source on page 98
Installing the JSA Hardware on page 103
Chassis Console Port Pinouts on page 9
Chapter 17: Installing the JSA Appliance
6— USB port
7— Console port
8— Fault LED
9— Hard disk activity LED
10— Power LED
111