Front-And-Rear-Mounting The Jsa Appliance Recessed In A Rack; Figure 20: Front-Rear Mounting Flush To Rack - Juniper JSA1500 Hardware Manual

Related
Documentation

Front-and-Rear-Mounting the JSA Appliance Recessed in a Rack

Copyright © 2018, Juniper Networks, Inc.
To mount JSA5500 using this option:
Insert four rack-mount screws on each side of the system to secure the front of the
1.
chassis to the equipment rack.
Slide the rear-mount rail brackets into the backs of the front rails on either side of the
2.
chassis and align with your rear equipment rack posts. Secure the rear-mount rail
brackets to your equipment rack with two rack-mount screws each.
Insert locking screws on the sides of the rear-mount brackets to secure the front and
3.
rear mounting brackets in place. See

Figure 20: Front-Rear Mounting Flush to Rack

Verify that the mounting screws on one side of the rack are aligned with the mounting
4.
screws on the opposite side and that the appliance is level.
Rack-Mount Installation Overview on page 89
Front-and-Rear-Mounting the JSA Appliance Recessed in a Rack on page 105
Mid-Mounting the JSA Appliance in a Two-Post Rack on page 109
This option provides additional front clearance in the equipment rack. It is used for a
larger chassis, like the JSA5500 appliance, that requires additional support when mounted
on the rack-mount system.
To mount the appliance using this option:
Remove the rear screws on each side of the system's front rails and the two small
1.
screws toward the front of the chassis.
Loosen the side-rail screws of the chassis and slide the front rails of the system
2.
backward, as far as they will move.
Chapter 17: Installing the JSA Appliance
Figure 20 on page 105.
Adjust rail length to fit the rack,
then secure the rear-rails
with a screw on both sides of the
chassis.
105