Replacing An Ac Power Supply On The Jsa Appliance; Replacing Ac Power Supply Cables On The Jsa Appliance - Juniper JSA1500 Hardware Manual

Replacing an AC Power Supply on the JSA Appliance

Related
Documentation

Replacing AC Power Supply Cables on the JSA Appliance

Copyright © 2018, Juniper Networks, Inc.
To replace an AC power supply:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Remove the power cord from the power supply.
2.
Push the tab on the left edge of the power supply to the right.
3.
Pull the power supply straight out of the chassis using the provided handle. Use one
4.
hand to support underneath the supply as you remove it.
Orient the replacement power supply so that the tab is on the left side.
5.
Using both hands, slide the replacement power supply straight into the chassis until
6.
the power supply is fully seated in the chassis slot. Make sure the tab on the left edge
of the power supply clicks into place.
Attach the power cord to the power supply. If the power supply is correctly installed
7.
and functioning normally, the power supply powers up immediately.
Field-Replaceable Units on the JSA Appliance on page 123
Replacing the Fan on the JSA Appliance on page 124
Replacing the Air Filter on the JSA7500 Appliance on page 126
Replacing AC Power Supply Cables on the JSA Appliance on page 127
Replacing a DC Power Supply on the JSA Appliance on page 128
Replacing DC Power Supply Cables on the JSA Appliance on page 129
To replace an AC power supply cord:
Unplug the power cord from the power source receptacle.
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Unplug the power cord from the appliance inlet on the power supply.
3.
Chapter 20: Maintaining the Hardware
127