Juniper Secure Analytics Hardware Guide
Related
Documentation
Connecting to a Management Device
100
Figure 17: Connecting JSA to a DC Power Source
1
1—
DC ring lug
2—Screw
Use the terminal screws to secure the power source cables to the power feed on the
3.
JSA appliance by attaching the twisted wires that are attached to the cables to the
appropriate terminals.
NOTE:
The red cable should be connected to the V+ terminal, and the
black cable should be connected to the V- terminal, respectively, as shown
in
Figure 17 on page
Attach the plastic safety cover.
4.
Connecting to a Management Device on page 100
Installing the CNA Module on the JSA1500 Appliance on page 110
Installing the JSA Hardware on page 103
Grounding the JSA7500 Appliance on page 97
Chassis Console Port Pinouts on page 9
You can control the Juniper Secure Analytics (JSA) appliance through a connected
management device (such as a desktop or laptop). Use the RJ-45 serial port and console
port to connect your laptop and desktop respectively.
2
3
3—
Safety cover
100.
Copyright © 2018, Juniper Networks, Inc.