STEP 3: Removing the Retainers
Retainers are attached to the machine to protect it from vibration during transportation. When installation
is complete, remove these retainers.
WARNING
This work must be performed before connecting the power cord.
If the power is turned on while this work is in progress, there is a risk of injury such as hands or fingers
getting caught.
CAUTION!
• Retainers are attached to the machine in two locations. Remove all the retainers. If any remain on the
machine, faulty operation or breakdown may occur when the power is switched on.
• Store the retainers carefully because they are needed again when transporting the machine.
• For transportation of this machine, contact your authorized Roland DG Corp. dealer.
Screws
Retainer B
You can store the retainers in the locations indicated in the illustration. Use the screws previously attached
to the retainers to attach them to the machine.
Hexagonal
wrench
Retainer B
Retainer A
Before Using This Printer
Retainer A
Hexagonal wrench
Screws
25