Make The Port Settings For The Software Rip - Roland VersaUV LEF-300 First Step Manual

3. Set the gateway address.
1.
On the screen for step 1.-8., press [ ] twice to display the screen shown below.
2.
Press [ ] twice to display the screen shown below.
3.
Press [ ] or [ ] to select the address number.
[GATEWAY ADDR.]: 255.255.255.255
For the value to enter for the gateway address, consult your network administrator. Here, "255.255.255.255"
is entered by way of example.
4.
Press [ ].
5.
Repeat steps 3 and 4 to set [GATEWAY ADDR.].
6.
When you have finished making the setting, press [ENTER].
Press [ ].
The screen shown in step 1. appears again.

Make the Port Settings for the Software RIP

• Install the software RIP and set it up. For the print destination, use the IP address set on the printer. For
information about how to make the settings, refer to the documentation for the software RIP.
• You can check whether the connection to the network has been made by using the printing-test feature
of the software RIP. For information about how to carry out a printing test, refer to the documentation for
the software RIP.
Before Using This Printer
43