System Setup Screen; Setting The Oscillator - Yamaha TF5 Reference Manual

6
Oscillator assignment buttons
Determine which channels the oscillator is sent to. You can select multiple channels.

Setting the oscillator

1. Touch the oscillator mode button and select the desired
mode.
2. Use the oscillator assignment buttons to determine
which channels the oscillator signal will be sent to.
Channel is selected
3. Touch the oscillator output button to turn on
the oscillator output.
4. While referring to the oscillator output level
meter, drag the oscillator level slider to adjust
the oscillator output level.
When the oscillator mode is set to SINE WAVE, you can
also adjust the frequency of the oscillator.
When the oscillator mode is set to BURST NOISE, you
can also adjust Width (duration of each noise burst) and
the Interval (duration of each silence between noise
bursts).

SYSTEM SETUP screen

Allows you to configure general mixer settings, as well as settings for OMNI OUT and Recall
Safe.
1
Bus Setup icon
Oscillator
Displays the BUS SETUP screen.
output button
2
OMNI OUT icon
Displays the OMNI OUT screen.
3
Slot Setup icon (V2.0 and
Displays the SLOT SETUP screen.
4
Recall Safe icon
Oscillator
Displays the RECALL SAFE screen.
level slider
5
+48V Master button
Master button that turns the console's phantom power feature on and off. When this
button is turned off, phantom power will not be supplied to any channels, even if their
+48V buttons are turned on.
Oscillator
6
Network icon
output meter
Displays the NETWORK screen.
7
Time icon
Displays the TIME screen.
- 20 -
(page 21)
(page 21)
laterpage 22)
(page 23)
(page 43)
(page 24)
(page 25)
Toolbar
TF Series
Reference Manual