Control Surface Operation With The Pro Tools Remote Layer - Yamaha 02R96 Owner's Manual

Control Surface Operation with the Pro Tools Remote Layer

This section explains the operation of the 02R96 control surface when the Pro Tools Remote
Layer is selected. 02R96 buttons and controls are referred to by the names printed on the
02R96 with the name of the corresponding Pro Tools function in parenthesis. For example,
"Press the AUX SELECT [AUX 1] (SEND A) button."
Display
This is the Pro Tools Remote Layer page, the various sections of which are explained below.
F2 (INSERT), F3 (CHANNEL), F4 (METER) buttons
These buttons are used to select the following display modes:
• [F2]—Insert Assign/Edit Display mode (see page 172)
• [F3]—Channel Display mode (see page 172)
• [F4]—Meter Display mode (see page 173)
TARGET
This parameter cannot be changed here. To change the target for this Layer, you must first
select another Layer, and then press the DISPLAY ACCESS [REMOTE] button. See "Assign-
ing a Target to the Remote Layer" on page 189 for more information.
COUNTER
This counter works in unison with the timecode counter
in Pro Tools. The display format is specified in Pro Tools.
The three check boxes indicate the currently selected for-
mat, as follows:
TIME CODE: Pro Tools timecode format set to "Time Code."
FEET: Pro Tools timecode format set to "Feet:Frames."
BEATS: Pro Tools timecode format set to "Bars:Beats."
When the Pro Tools timecode format is set to "Minutes:Seconds" or "Samples," no check
boxes are selected.
CURSOR MODE
The currently selected Cursor mode is displayed here: NAVIGA-
TION, ZOOM, or SELECT. Cursor modes are selected by using the
[INC] (CURSOR MODE) button.
SELECT ASSIGN
This indicates the current function of the Encoders. For example,
Pan (PanR), SndA, SndB, SndC, SndD, or SndE.
Control Surface Operation with the Pro Tools Remote Layer
171
02R96—Owner's Manual