Device Control Block (Mks-8036A Search Dial Module, Option) - Sony MVS-8000 User Manual

When the resizer control mode is
enabled (for the MVS-8000G only)
Turning the trackball allows the key to
which the resizer applies to be moved in the
x-axis and y-axis directions, and zoomed in
and out.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the trackball operation
is switched to a finer control. (fine mode)
d Z-ring
When the positioner operation mode is
enabled
When the [USER] button is selected, by
turning the ring you can adjust the size of
the pattern.
When the three-dimensional transform
operation mode is enabled
Turn this ring to control the z-axis in a
three-dimensional transform.
When the [SRC] or [TRGT] button is held
down, the Z-ring operation is switched to a
finer control. (fine mode)
When the effect run control mode is
enabled
By turning the Z-ring, you can run the
keyframe effect, independent of the STOP
NEXT KF, EFF LOOP, and similar settings
in the keyframe control block. Turn
clockwise to run the effect in the normal
direction, and counterclockwise for the
reverse direction.
Device Control Block (MKS-8036A Search Dial Module,
Option)
The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
272
Names and Functions of Parts of the Control Panel
When the resizer control mode is enabled
(for the MVS-8000G only)
By turning the ring, you can zoom the key
to which the resizer is applied, and change
the aspect ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the Z-ring operation is
switched to a finer control. (fine mode)
When the VTR/disk recorder/frame
memory operation mode is enabled
Turning the Z-ring controls the tape
transport/disk drive/frame memory clip
operations, at a speed determined by the
operating buttons. Turn clockwise for the
normal direction, and counterclockwise for
the reverse direction.
e MENU button
Press this button, turning it on, to enable
adjusting the parameters allocated to the
knobs in the menu using the trackball and
Z-ring.
In the case of the DME menu, the operation
applies to the selected DME channel.
In VTR/disk recorder/frame memory
operation mode, press this button, setting it
to On, to make it possible to carry out
timeline start/stop point setting operation
for the device selected with the device
selection buttons (timeline setting mode).
Using the device control block (MKS-
8036A search dial module
can directly operate an XDCAM, disk
recorder, VTR or other external device,
frame memory clip, or shotbox. The device
1)
, option), you