Setup Relating To Dcu Input/Output; Setup Relating To The Router Interface And Tally Interface - Sony MVS-8000 User Manual

Interface with external devices (Device Interface)
• Editor Protocol: Set the protocol to be used on the Editor port.
• Editor Port Setting: Make settings relating to the control of the four editor
• GPI Input: Set the GPI input ports and trigger polarities, and make the
• GPI Output: Set the GPI output ports and trigger polarities, and make the

Setup Relating to DCU Input/Output

In DCU setup, carry out settings particular to the DCU.
You can make the following settings.
• Input Config: Assign GPI inputs to Parallel input ports.
• GPI Input Assign: Make GPI input settings.
• Output Config: Assign GPI outputs to parallel output ports inserted in an
• GPI Output Assign: Make GPI output settings.
• Serial Port Assign: Set the protocol to match the devices connected to a 9-
Setup Relating to the Router Interface and Tally
Interface
Carry out settings relating to the interface with the routing switcher, and
settings relating to the tally interface.
You can make the following settings.
Router interface setup (Router)
These settings are common to the parallel tally and serial tally.
• Matrix Size: Assign the switcher matrix of each switcher processor to S-Bus
• External Box: To obtain the signal selection status of external devices with
• Alias Name Gp: Set the group number for an S-Bus description name to be
196
Setup
ports installed in the DME.
action settings.
action settings.
option slot.
pin serial port. You can also select the control panel used to control each
device.
space, and select the matrix size and positioning level, source address
settings, and so on.
a parallel input, assign a matrix as an external selector in the S-Bus space.
Make the matrix size, assignment level, source address, and other settings.
displayed in the source name displays for a cross-point operation.