Switcher Setup - Sony MVS-8000 User Manual

• Sensitivity: Adjust trackball, joystick and double-click sensitivity, or set the
• Macro: Set the macro execution mode.
Screen saver and other settings (Maintenance)
• Screen Saver: Make the menu screen saver settings.
• LCD Brightness: Adjust the LCD brightness.
• LED Brightness: Adjust the LED brightness.
• Switch Brightness: Adjust the switch brightness.
• Touch Beep: Select whether or not to sound a beep when a menu operation
• Touch Panel Calibration: Calibrate the touch panel.
• Initial Menu Set: Specify the menu to be displayed at menu startup.

Switcher Setup

In switcher setup, make settings particular to the switcher processor.
You can make the following settings.
Settings relating to overall switcher configuration (Config)
• System Phase: Adjust the switcher internal reference phase.
• Switch Timing: Specify the timing of video switching.
• M/E Config: Set the program configuration for the M/E and P/P outputs.
192
Setup
– [AUTO TRANS] or [TAKE] button during auto transition execution
– [RUN] button during keyframe execution
– [AUTO TRANS] and [CUT] button replacement
– [TRANS PVW] button
– Key delegation [DME1] to [DME4] button selection mode
– Key delegation [XPT HOLD] button operation mode
– Selection of signal assigned to the auxiliary bus control block key source
bus (either key signal only, or either video signal or key signal selectable)
relationship between the angle of the search dial and the playback speed.
is carried out.
– Standard mode: Fix the maximum of four outputs (Out1 to 4) and
program output configuration as follows.
Out1: Program output
Out2: Preview output
Out3: Clean output
Out4: Key preview output
Program output: Clean output + key 1 + key 2 + key 3 + key 4
– Multi-program mode: Increase the number of M/E or P/P programs, and
assign any of the following to the maximum of six outputs (Out1 to 6). (M/
E Output Assign)