Dme Setup - Sony MVS-8000 User Manual

Link settings (Link)
• Internal Bus Link: Make a setting of the bus link function that links
together two buses internal to the switcher.
• GPI Link: Make settings for linking any cross-point buttons or [CUT] and
[AUTO TRANS] buttons in the cross-point control block and GPI output
ports.
• M/E Link: Make settings to link together two M/E banks.
• Key Trans Link: Make settings to link key transitions.
External device connections (Device Interface)
• Remote Assign: Set the use of the four 9-pin ports.
• GPI Input: Set the GPI input ports and trigger polarities, and make the
action settings.
• GPI Output: Set the GPI output ports and trigger polarities, and make the
action settings.
• Aux Control: Set whether operations on the AUX buses from the four 9-pin
ports are inhibited.
• DME Type Setting: When the DME is an MVE-9000 or MVE-8000A, carry
out interface settings, and for an SDI interface set the AUX bus outputs and
reentry inputs.

DME Setup

In DME setup, carry out settings particular to the DME processor.
You can make the following settings.
Input signal settings (Input)
• Initial Crop: Make the initial crop setting.
• Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated
by the DME internal matte generator on or off.
• System Phase: Adjust the operation timing of the whole system with respect
to the reference signal.
• TBC Center: Set the TBC window center position.
Output signal settings (Output)
These settings are possible only when the DME is an MVE-9000 or SDI-
interfaced MVE-8000A.
• Monitor Output: Set the signals output from the four monitor output
connectors.
• Clip Adjust: Adjust the clip levels of DME1 and DME2 outputs.
195
Setup